TECHNO-Injection 306
Rubber-elastic, 3 C acrylate gel, multi purpose applicable
- Very low viscous acrylate gel
- Very good penetration
- Proven stability of at least 16 years
TECHNO-Injection 310
Adjustable, low viscous rigid acrylate resin with high final strength.
- Low viscous
- Very good penetration
- High final strength
TECHNO-Injection 305
Adjustable, low viscous, quickly reacting 3 C acrylate gel
- Quickly reacting
TECHNO-Injection 201
2-component injection resin based on polyurethane
- Officially approved system
- Proven against water pressure of 7 bars
- Approved for use in CHF and LMSS plants
TECHNO-Injection 202
2-component high flexible injection resin based on polyurethane
- Universal and economical
- Highly flexible < -50°C
TECHNO-Injection 202 LV
Low-viscous, 2-component injection resin based on polyurethane
- Very low viscous
- For hairline cracks
TECHNO-Injection 270 L
Slowly curing, from ridged to tough elastic, 2K polyurethane resin, which foams up in contact with water
- Stabilizing and sealing of masonry
- Adjustable pot life (90 min – 58 sec.)
- Groundwater friendly approved
TECHNO-Injection 101
Single-component injection material based on extra-fine cement
- Very high compressive-strength
- For injection in cracks above 0.2 mm
TECHNO-Injection 102
Minerally, single component injection glue based on trass chalk according to DIN 1060
- Dry and wet cracks >0,2 mm in brickstone and natural stone
- No ettringite formation
TECHNO-Injection 103
Ready to use dry mixture based on cement, non-shrinking.
- For injection in cracks above 0.375 mm
- Non-shrinking
- For VPRESS® injection hose with 10mm inner-Ø
TECHNO-Injection 104
Injection and anchor mortar
- Does not shrink
- Is easy to process
- Frost protected